Särmä TST Hanger Utility Pouch

A hanging, dangling utility pouch for attaching onto plate carriers and other vests and load-bearing platforms. Offers a good amount of room and organization options to store all kinds of miscellaneous trinkets within easy reach.

• Dimensions 22 x 15 x 7 cm / (8.5" x 6" x 3")
• Hook-and-loop attachment for plate carriers etc.
• Two-way zipper closure
• 10 x 15 cm / 4" x 6" loop on the outside for patches
• Two 10 x 14 / 4" x 5.5" cm mesh compartments on the inside
• The entire rear inner wall is loop-surface
• Six elastic chemlight/pen loops on the back
• Drainage grommet on the bottom
• 1000D Cordura (snow camo 1000D Foxdura), NIR compliant

A hanging utility pouch is a clever way to increase the load-carrying capability and organization options of your crammed plate carrier or chest rig. After you've filled up on magazines, a radio, grenades, and a first aid kit you're rarely left with much room to spare. This kind of pouches solve that issue by using that otherwise wasted space for general purpose use!

Make sure the hook-and-loop attachment is compatible with your vest/carrier/rig! The way the attachment is made is compatible with most plate carriers and chest rigs out there, but not all. So before you buy just check your gear to see if the hook-and-loop is the right way around, otherwise you'll end up sad or sewing.

Made in the EU

The green and M05 woodland camo pouches are manufactured in co-operation with Finn-Savotta Oy (Finland's leading military and outdoors gear manufacturer and the main load-bearing equipment contractor for the Finnish Defence forces). Depending on the situation production runs are sewn either in Savotta's Finnish or Estonian factory, sometimes even partially in Finland and partially in Estonia. The little printed tags tell where exactly each particular product was sewn. The M05 snow camo pouches are made in the Czech Republic by Finnish CPE.